REVO S 2PH            
Solid-State Relay

• Revo S has been specifically designed to save space and labour
• These simple units can be connected with REVO PC to manage multizone
  system this minimize your energy cost by controlling synchronization and
  power limit on each zone
• Integrated fuse + fuse holder is necessary to have a complete
  power control zone including current transformer and optional circuit board
• Flat Cable Wiring System (option) to connect in plug in mode many Revo S
  when HB alarm or analog input are used
• Input signal: SSR, Analog as an option
• Zero Crossing, Burst Firing available at 4, 8 or 16 Cycles at 50%
  of Power demand
• Electronic fully isolated from power with constant current drain on input.
• Heater Break alarm option to diagnose partial or total load failure
  and Thyristor Short circuit
• Fuse and Fuse holder available as an option
• Current transformer integrated (with Heather Break option)
• Special design for Heat sink with very high dissipation value
• Comply with EMC, cUL (pending)
• DIN RAIL side by side mounting
• IP20 Protection